TFT32 Full Color LCD Touch Screen + MKS-GEN L Mainboard with 5Pcs Red A4988 Driver 3D Printer Controller Board Kit

Description

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle’s details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  About MKSGEN Mainboard:
                   
                  1, Assemble 2560 and ramps1.4 on a board to solve the problem of complex interface and easy failure of the Ramps1.4 interface.
                  2. Replaceable motor drive, support 4988 drive and 8825 drive, TMC2100 drive, s109 drive
                  3, Reserved external drive signal, can be connected to the external drive to drive 57, 86 motors.
                  4, The use of high-quality MOSFET tube, heat dissipation better, to ensure long-term stability.
                  5, The use of dedicated power chip, support 12V-24V power input, to solve the Ramps voltage conversion chip heating, inadequate power supply problem.
                  6, 24V input can be accepted. Under the same system power, the hotbed current can be reduced to 1/4, effectively solving the problem of heat pipe MOS heating.
                  7, The use of open source firmware Marlin, configuration and ramps1.4 exactly the same, can directly replace Ramps1.4.
                  8, Can be directly connected to the 2004LCD display and 12864LCD display, can support TFT28, TFT32 touch screen.
                  9. Reserve the motor pulse and direction output port to facilitate the external high current to be connected to a large current (such as 2A, 5A) motor drive circuit.
                  10. Retain the Servos, AUX-1, and AUX-2 interfaces on Ramps1.4, providing three 5V outputs and three 12V output interfaces.
                   
                  About TFT32 Display:

                  Compatible with Marlin/Smoothieware/Repetier firmware
                  Appearance size: 110mmX65mm
                  Hole size: 102mmX57mm

                  Color touch screen: 3.2 inch touch screen

                  Microprocessor: 32-bit STM32 processor
                  Update method: SD file update
                  Support SD card, U disk
                  Support file format: Gcode

                  Scalable application: WIFI module, after the shutdown module,Cut-off inspection switch, power-off continuous, external card slot

                  Package Included:

                  1 x MKS-GEN L motherboard
                  1 x TFT32 display
                  5 x A4988 red drive
                  5 x Heat sink
                  1 x USB cable
                  1 x FC flat cable

                  Reviews

                  There are no reviews yet.

                  Be the first to review “TFT32 Full Color LCD Touch Screen + MKS-GEN L Mainboard with 5Pcs Red A4988 Driver 3D Printer Controller Board Kit”

                  Your email address will not be published. Required fields are marked *