CNC Shield Board + 4Pcs A4988 Stepper Motor Driver For Arduino 3D Printer

Description

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle’s details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  CNC Shield Board:

                  Version: 3.0
                  Color: Red
                  Size (L*W*H): 68 x 53 x 18 mm
                  Voltage: DC 12~36 V (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)

                  Features:

                  1. Uses removable A4988 or DRV8825 compatible stepper drivers.
                  2. The extension board can be used for carving machine, 3 d printer driver expansion board
                  3. GRBL 0.8 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals)
                  4. PWM Spindle and direction pins,4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
                  5. Compact design. Stepper Motors can be connected with 4 pin molex connectors or soldered in place.
                  6. Please note that this is an unassembled kit and Basic soldering skills are needed.

                  A4988 Stepper Motor Driver:

                  Color: Red
                  Size (L*W*H): 20 x 15 x 10 mm
                  Thermal shutdown circuitry: Yes
                  Crossover-current protection: Yes
                  Ground fault protection: Yes
                  Load short-circuit protection: Yes
                  Compatible logic supply: 3.3V and 5 V
                  Five selectable step modes: full, 1/2, 1/4, 1/8 and 1/16

                  Features:

                  1. Mix with slow current decay modes.
                  2. Internal UVLO and Low RDS (On) Output.
                  3. Automatic current decay mode detection/selection.
                  4. Synchronous rectification for low power dissipation.
                  5. Warning: Connecting or disconnecting a stepper motor while the driver is powered can destroy the driver.

                  Package includes:

                  1 x Engraver CNC Shield Board
                  4 x A4988 Stepper Motor Driver

                  Note: Manual measuring, please allow 1 ~ 3 cm error, thank you.

                  ,,,,

                  Reviews

                  There are no reviews yet.

                  Be the first to review “CNC Shield Board + 4Pcs A4988 Stepper Motor Driver For Arduino 3D Printer”

                  Your email address will not be published. Required fields are marked *